Information about forums, live demonstrations, Accelerating Talents and panel discussion. The entire forum program is available in the event database.
Product presentation Hall A1
11:00-11:30 h | Hall A1 At the Digitaltest booth hall A1/152
A component failure had to be searched and identified manually using a magnifying glass ,a time-consuming process. With Digitaltest's Complete Optical Repair Solution (CORS), the fault location is now displayed as a live image via a camera system, so that faster analysis and repair is possible.
Subjects: Electronic Manufacturing Services (EMS)
Type: Product presentation
Speech: German, English
The procedure for troubleshooting so far:
The fault on an assembly had to be searched for and identified manually using a magnifying glass. This procedure was and is time-consuming, especially as miniaturization and high packing density progressed.
Digitaltest's solution for the future is Complete Optical Repair Solution (CORS):
The IP-3000 optical inspection system is remotely controlled via the QMAN Repair Stations Sofware and now displays the fault location as a live image on a high-resolution monitor. This enables faster analysis and repair, which in turn saves time and money. QMAN imports the test results from various test processes. In the event of a fault, the defective assembly can be quickly repaired with QMAN. The solution lies in the camera system of the IP-3000 inspection system: the connected side cameras enable solder joint inspection and the detection of short circuits.
The advantages are obvious:
- Assembly faults are located faster by cameras
- as the repair is worthwhile again, less rejects are produced
- thus both resources are saved
- as well as protecting the environment